Robertshaw RS6220 Installation Manual Page 1

Thank you for purchasing a Robertshaw®thermostat. This manual willdescribe how to install and test the Robertshaw single stage thermostatsRS4110, RS51

Default EnergyStar™ Settings for RS5000 and RS6000The RS5110, RS5220, RS6110 and RS6220 are programmable thermostatsand are preprogrammed with a sched

Press to immediately force the heating or cooling system on or off.Press to also step through the second stages (2 stage models).NOTE: When a heat s

Setting the ModePress the button to cycle through the available modes.OffHeatCoolEmergency Heat (2 stage Heat Pump units)Automatic changeoverSetting

2. Enter the digits for the password by pressing the and buttons.Press the to move to the next digit. Press to move back.If the wrong password is

Five Year Limited WarrantyInvensys Controls warrants to the original contractor installer, or to the originalconsumer user, each new Robertshaw thermo

IMPORTANT SAFETY INFORMATION WARNING:• Always turn off power at main fuse or circuit breaker panel beforeinstalling, removing, cleaning, or servicing

Installing the Robertshaw Thermostat BaseNOTE: For new installations, mount the thermostat on an inside wall, five feetabove the floor. Do not install

System Switch SelectionThe body of the thermostat has two switches on the backside. They areaccessible by removing the backplate from the body. The in

5Terminal FunctionOne Stage Models RS4110, RS5110 and RS6110TERMINALEQUIPMENT TOCONNECTDESCRIPTIONC24V ACCommon ConnectionFor input of 24V AC common s

6CompressorContactorReversingValveFan RelayGOBY1W1Y2W2ERH/RRCCLTransformerHot120 VacRemove jumper ifseparate coolingtransformer ispresent.When used as

7CompressorContactorFan RelayGOBY1W1Y2W2ERH/RRCCLTransformerHot120 VacRemove jumper ifseparate coolingtransformer ispresent.When used asNon-Heat Pump

Applying PowerBefore applying power, fill in the chart in the Pop-Up Wizard section ofthis manual.When 24V AC power or battery power is first applied

Pop-Up WizardThe Wizard routine will display factory default settings. Each setting willdisplay for ten seconds. Use the or buttons to change the se